Griswold Products

Reliable products that perform at the highest levels

For over 70 years, our history of experience shows our commitment to providing quality centrifugal pumps.

View Our Products

Griswold Markets

Unmatched in technical capabilities

Griswold overcomes unique operational challenges for applications in the safest, most efficient and profitable way possible.

View Our Markets

Centrifugal Pump Minute

All things relating to centrifugal pumps

Griswold's platform to provide educational resources for centrifugal pump technology and industry news.

View Latest News

Pump Inspection - ANSI Centrifugal Pumps

by PSG | Jul 04, 2022

Why Inspect Your Pump?

Once out of service and disassembled, it’s crucial to conduct a thorough inspection of an ANSI centrifugal pump before returning it to service. By examining and/or testing each part prior to reassembly, operators can ensure that all features of the pump are functioning properly, require no maintenance and are able to resume service. This evaluation can also help operators determine the lifespan of a part, or whether a particular area requires cleaning or remachining.

Conducting an ANSI Centrifugal Pump Inspection

When conducting a pump inspection, Griswold® recommends beginning with an assessment of the pump’s hydraulic components. In this assessment, operators should check the casing for excessive wear, gouging or pitting on the hydraulic surfaces, especially internal to the flow path. Should you notice a defect greater than ⅛” of wear, it’s time to replace the casing.

Next, you should examine the gasket surface where the case gasket sits during operation. Checking here for defects helps eliminate the possibility of leakage.

Moving onto the impeller, operators should inspect it to ensure that no defects, gouges or pits are present in the top surface of the impeller. While evaluating the impeller, we recommend that operators check the pump out veins on the back side for any corrosion or pitting in the casting. If either are evident, the impeller requires replacement.

You should next go over the seal chamber, otherwise known as the stuffing box. This feature is essential to fluid containment, so it’s important to look for any wear or defects greater than ⅛”. The seal gland gasket and casing gasket within the seal chamber must also be free of any defects, as this can affect the seal efficacy.

Additionally, while the pump is out of service operators should examine the rotating assembly, including the shaft and bearing housing. If the dimensions do not meet specifications, the shaft should be replaced. While inspecting the rotating assembly, operators should look for any wear on the seal area of the shaft, as well as the sleeve, if present. Following this assessment, move on to inspecting the bearing housing. Checking the diameter of the thrust bearing and ensuring there are not any defects in the snap ring groove and the O-ring groove can help protect the longevity of your pump.

Proceeding With Reassembly

After this initial inspection has been completed, it’s important to continue evaluating the pump as you reassemble to confirm that all components are within tolerance. You should begin by observing the end play of the shaft, using a dial indicator to see how much play there is and whether the performance meets manufacturers’ recommendations. Using the dial indicator again, we suggest testing the run out of the shaft next. This allows you to measure shaft deflection near the seal. Once this meets manufacturer standards, move on to check the run out of the impeller, re-installing the stuffing box onto the shaft and once again utilizing the dial indicator to ensure a standard run out.

Returning the Pump to Service

Once these visual and dimensional inspections have been fulfilled and each part is cleared for service, you can finish assembly with the casing. After concluding reassembly, the pump is ready to go back into service. By following this critical inspection process, operators can secure safe, reliable pump performance.

 

Click here to watch the video.